Intervsan Routing - Cisco AJ732A - MDS 9134 Fabric Switch Release Note

Limitations and Restrictions
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Restart Fabric Manager Server.
Step 6
Maximum Number of Zones Supported in Interop Mode 4
In interop mode 4, the maximum number of zones that is supported in an active zone set is 2047, due to
limitations in the connected vendor switch.
When IVR is used in interop mode 4, the maximum number of zones supported, including IVR zones,
in the active zone set is 2047.

InterVSAN Routing

When using InterVSAN Routing (IVR), it is recommended to enable Cisco Fabric Services (CFS) on all
IVR-enabled switches. Failure to do so may cause mismatched active zone sets if an error occurs during
zone set activation.
Upgrading the SAN-OS Software on the MDS 9222i Switch
On an MDS 9222i switch, an upgrade from SAN-OS Release 3.2(x), Release 3.3(1), or Release 3.3(1a)
to SAN-OS Release 3.3(1c) fails when there is an active FC-Redirect configuration (created by Cisco
SME or Cisco DMM applications) on the switch. An active FC-Redirect configuration is defined as:
FC-Redirect configuration for hosts or target connected locally
FC-Redirect configuration created by application running on that switch.
If an upgrade is attempted when an active configurations is present, the switch will go into a disruptive
upgrade.
Java Web Start
When using Java Web Start, it is recommended that you do not use an HTML cache or proxy server. You
can use the Java Web Start Preferences panel to view or edit the proxy configuration. To do this, launch
the Application Manager, either by clicking the desktop icon (Microsoft Windows), or type ./javaws in
the Java Web Start installation directory (Solaris Operating Environment and Linux), and then select
Edit> Preferences.
If you fail to change these settings, you may encounter installation issues regarding a version mismatch.
If this occurs, you should clear your Java cache and retry.
Cisco Storage Media Encryption
The following limitations are described for Cisco SME:
•
•
•
Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 4.1(1b)
44
Cisco SME Configuration Limits, page 45
Deleting Cisco SME Interfaces, page 45
Emulex Driver Version, page 45
OL-17675-02