Cisco AJ732A - MDS 9134 Fabric Switch Release Note page 49

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Resolved Caveats
•
•
•
•
OL-17675-02
CSCsu80534
Symptom: An MDS 9124 switch, MDS 9134 switch, MDS 9222i switch, Cisco Fabric Switch for
IBM BladeCenter, or Cisco Fabric Switch for HP c-Class BladeSystem, may reboot with reason
Unknown or Watchdog Timeout when the switch has been up for 497 days. The following messages
may be displayed:
switch#show system reset-reason
--- reset reason for Supervisor-module 1 (from Supervisor in slot 1) ---
1) No time
Reason: Unknown
Service:
Version: 3.1(2)
or,
switch#show system reset-reason`
----- reset reason for Supervisor-module 1 (from Supervisor in slot 1) ---
1) At 203437 usecs after Fri Jul
Reason: Watchdog Timeout
Service:
Version: 3.1(2)
Issuing the show logging onboard command will contain a Card Uptime Record with an uptime of
497 days. the following message may be displayed:
Thu Sep 25 19:09:33 2008:
----------------------------------------------
Uptime: 42946218, 497 days 1 hour(s) 30 minute(s) 18 second(s)
Reset Reason: Unknown (0)
Card Mode..........................:
Workaround: This issue is resolved.
CSCsg49151
Symptom: If you bring up more than one link at a time between two VSANs that have overlapping
domains and at least one of the switches is SDV enabled, one link will become isolated. The other
links will come up, even though the domains are overlapping. In addition, the SDV virtual domains
will change, causing traffic disruption on all devices associated with their old value.
Workaround: This issue is resolved.
CSCsl71227
Symptom: Using Fabric Manager Release 3.2(2), if you have an enclosure with multiple ports and
you then use the Data Migration Wizard to create a job with that enclosure as the existing storage
but don't select all the storage ports in the enclosure, an error is displayed in the creation wizard.
Workaround: This issue is resolved.
CSCso28570
Symptom: On the MDS 9222i module, an upgrade from SAN-OS Release 3.2(x) to Release 3.3(1a)
fails when there is an active FC-Redirect configuration (created by Cisco SME or Cisco DMM
applications) on the switch. An active FC-Redirect configuration is defined as:
FC-Redirect configuration for hosts or target connected locally
–
FC-Redirect configuration created by an application running on that switch.
–
If an upgrade is attempted when such active configuration is present, the switch will go into a
disruptive upgrade.
Workaround: This issue is resolved.
Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 4.1(1b)
4 18:32:02 2008
Card Uptime Record
Runtime
Caveats
49