Cisco AJ732A - MDS 9134 Fabric Switch Release Note page 57

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
CSCsr59290
•
Symptom: Splitter errors occur on a first Control Virtual Target (CVT), when a second CVT is
created on the same SSM module. This occurs when a second CVT is created on the same Data Path
Processor (DPP) as that of the first one. This also occurs when the DVT and the RP appliance target
ports use the same front panel ports as the DPP.
Workaround: This issue is resolved.
CSCsr96205
•
Symptom: When generating a scheduled report, the pictures are not displayed.
Workaround: This issue is resolved.
• CSCsr98144
Symptom: If a sync loss is received for a non-existing fabric, the XBAR manager transitions to a
state from which it does not exit. Issuing the show system internal xbar internal event-history
command displays the following:
FSM:<module 4> Transition at 385036 usecs after Wed Jul 2 11:42:22 2008
Previous state: [XBM_MOD_ST_INSERTED]
Triggered event: [XBM_MOD_EV_LC_LOST_SYNC]
Next state: [XBM_MOD_ST_RESYNC]
FSM:<module 4> Transition at 393318 usecs after Wed Jul 2 11:42:22 2008
Previous state: [XBM_MOD_ST_RESYNC]
Triggered event: [XBM_MOD_EV_LC_LOST_SYNC]
Next state: [No transition found]
FSM:<module 4> Transition at 437193 usecs after Wed Jul 2 11:44:49 2008
Previous state: [XBM_MOD_ST_RESYNC]
Triggered event: [XBM_MOD_EV_FAB_ADD]
Next state: [No transition found]
Workaround: This issue is resolved.
CSCsu29585
•
Symptom: A DMM Method-2 job that is in progress will move to the failed state if zone changes
are made to the zone entries comprising the New Storage port in the active zone set.
Workaround: This issue is resolved.
CSCsu31223
•
Symptom: When using SME, snmpd may fail due to a slow memory leak.
Workaround: This issue is resolved.
CSCsu56780
•
Symptom: A Solaris iSCSI host generates the following warning during long text responses:
iscsi: [ID 498442 kern.warning] WARNING: iscsi
session(5) protocol error - received unknown itt:0x0 - protocol error
This issue occurs when there are a large number of iSCSI target names to report in multiple text
response PDUs, in response to SendTargets requests from the iSCSI host. The exact number of target
names that will trigger this issue vary depending on each target name length.
Workaround: This issue is resolved.
CSCsu88430
•
Symptom: In some instances, saving a configuration using Fabric Manager may be unsuccessful.
As a result, the configuration may be lost.
OL-17675-02
Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 4.1(1b)
Caveats
57