Cisco AJ732A - MDS 9134 Fabric Switch Release Note page 12

Migrating from Supervisor-1 Modules to Supervisor-2 Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Table 6 Module Support Matrix for Cisco MDS SAN-OS 3.x (continued)
Module Description
DS-X9112 12-port 4-Gbps Fibre Channel Switching
Module
DS-X9124 24-port 4-Gbps Fibre Channel Switching
Module
DS-X9148 48-port 4-Gbps Fibre Channel Switching
Module
DS-X9704 4-port 10-Gbps Fibre Channel Switching
Module
DS-X9302-14K9 14/2-port Multiprotocol Services
(MPS-14/2) Module
DS-X9016 16-port 1-, 2-Gbps Fibre Channel Switching
Module
DS-X9032 32-port 1-, 2-Gbps Fibre Channel Switching
Module
DS-X9032-SSM 32-port Storage Services Module (SSM)
DS-X9308-SMIP 8-port 1-, 2-Gbps IP Switching Module
DS-X9304-SMIP 4-port 1-, 2-Gbps IP Switching Module
Migrating from Supervisor-1 Modules to Supervisor-2 Modules
As of Cisco MDS SAN-OS Release 3.0(1), the Cisco MDS 9509 and 9506 Directors support both
Supervisor-1 and Supervisor-2 modules. Supervisor-1 and Supervisor-2 modules cannot be installed in
the same switch, except during migration. Both the active and standby supervisor modules must be of
the same type, either Supervisor-1 or Supervisor-2 modules. For Cisco MDS 9513 Directors, both
supervisor modules must be Supervisor-2 modules.
Migrating your supervisor modules is a disruptive operation.
Caution
Migrating from Supervisor-2 modules to Supervisor-1 modules is not supported.
Note
To migrate from a Supervisor-1 module to a Supervisor-2 module, refer to the step-by-step instructions
in the
Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 4.1(1b)
12
Cisco MDS 9000 Family CLI Configuration
MDS 9500 MDS MDS
Series 9222i 9216i
Yes Yes Yes
Yes Yes Yes
Yes Yes Yes
Yes Yes Yes
Yes No Yes
Yes No Yes
Yes No Yes
Yes Yes Yes
Yes No Yes
Yes Yes Yes
Guide.
MDS MDS
9216A 9216
Yes No
Yes No
Yes No
Yes No
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
OL-17675-02