HP AA979A - StorageWorks SAN Switch 2/8V Release Note page 34

Replace Table 12 on page 76 with the following:
Table12: WWN Bezel LED Patterns
LED location
and purpose
16-Port card/CP
card Power
16-Port card/CP
card Status
34 Core Switch 2/64 and SAN Director 2/128 installation guide, part number: AA-RVUSC-TE
LED Color Status
Steady green Power is OK
Flashing green Power to port card is OK;
however, this LED flashes if the
port card status LED is flashing.
No light (LED is No port card is present or the
off) power source is unavailable.
NOTE: Check the individual port card (see Figure 15 on page 81) or CP
card power LEDs (see Figure 16 on page 85) on the port side of the chassis to
confirm the LED patterns.
Steady Amber Port card is faulty.
Slow-flashing Port card is not seated correctly
amber (2 or is faulty.
seconds on;
then 2 seconds
off)
Fast-flashing Environmental range exceeded
amber (1/2 or port card failed diagnostics
second on; (run during POST or manually).
then 1/2
second off)
No light (LED is Port card is either healthy or
off) does not have power.
Recommended Action
No action required.
Check port card status LED
and determine if it is
flashing slow (2 second
increments) or fast (1/2
second increments) and then
take appropriate action.
Insert port card, or check
AC switch and power
source.
Check port card.
Pull card out and reseat it. If
LED continues to flash,
replace card.
Check for out-of-bounds
environmental range and
correct it. Replace card if it
fails diagnostics.
Verify that the port card
power LED is on.