HP A7533A - Brocade 4Gb SAN Switch Base Release Note page 27

Hp storageworks fabric os 6.1.1b release notes (5697-7838, march 2009)

Hide thumbs Also See for A7533A - Brocade 4Gb SAN Switch Base:

Table of Contents

Port RSCNs are sent to DPC (VIs and VTs) whenever the configuration

changes, which is unrelated to VI/VT. This affects any application that

uses frame redirect zoning.

With both RD and TI zones configured, a connectivity issue can occur

after hafailover and hareboot.

Frame drop was observed on 4-Gb and 8-Gb switches due to a time

window when a port in a trunk goes offline and the route is not properly

recalculated.

An incorrect status (marginal) occurred when the power cord was un-

plugged.

Unexpected errors encountered during Tape Cancel and Selective

Reset processing during tape creation/restore with FICON tape.

Fixed in Fabric OS 6.1.1b

Workaround: Run cfgdisable and

cfgenable commands.

Fixed in Fabric OS 6.1.1b

HP StorageWorks Fabric OS 6.1.1b release notes

Table of Contents