HP A7533A - Brocade 4Gb SAN Switch Base Release Note page 25

Hp storageworks fabric os 6.1.1b release notes (5697-7838, march 2009)

Hide thumbs Also See for A7533A - Brocade 4Gb SAN Switch Base:

Table of Contents

The aaaconfig command online help text needs to be corrected to

clearly indicate LDAP cannot be configured while FIPS is enabled.

FR-18i faulted after overnight stress testing.

A TI zone with an invalid (too high) port number can cause a kernel

panic.

ARRd Daemon had multiple restarts that ultimately let to a KSWD event.

Fast Write can obtain incorrect FCP command data length if the op-

tional additional CDB length is selected.

Hardware LED shows error status (flashing amber or green), even

though all FRUs are okay.

Invalid Tx/Rx rate can be computed if a polling cycle takes place when

a domain name has not been assigned.

An EZ Switch Manager validation error occurs on existing zones due

to devices of type initiator+target or unknown being treated like stor-

age.

The Accept CT_IU to GA_NXT Request frame is being rejected by a

third-party storage device because the frame size is 680 bytes.

HP 8/80 FRU faulty status not recovered after connecting to correct

power supply after operating with a single power supply.

A Tape Selective Reset error occurs due to incorrect handling of Early

End Synchronization status.

A FICON Device Level Ack Emulation Processing error occurred.

Fixed in Fabric OS 6.1.1.

HP StorageWorks Fabric OS 6.1.1b release notes

Table of Contents