Electrical Safety; General Guidelines; Power Cord - Xerox 6000V_B User Manual

Safety

Electrical Safety

General Guidelines

WARNING:
openings on the printer. Contact with a voltage point or shorting out a part could
result in fire or electrical shock.
Note: Leave the printer on for optimum performance; it does not pose a safety hazard. If, however,
you do not use the printer for an extended period, turn it off and unplug it.
The following are hazards to your safety:
• The power cord is damaged or frayed.
• Liquid is spilled into the printer.
• The printer is exposed to water.
• The printer emits smoke, or the surface is unusually hot.
• The printer emits unusual noise or odors.
• The printer causes a circuit breaker, fuse, or other safety device to activate.
If any of these conditions occur, do the following:
1. Turn off the printer immediately.
2. Disconnect the power cord from the electrical outlet.
3. Call an authorized service representative.

Power Cord

• Use the power cord supplied with your printer.
• Plug the power cord directly into a grounded electrical outlet. Make sure that each end of the cord
is securely connected. If you do not know if an outlet is grounded, ask an electrician to check the
outlet.
• Do not use a ground adapter plug to connect the printer to an electrical outlet that does not have
a ground connection terminal.
• Only use an extension cord or power strip designed to handle the electrical current capacity of the
printer.
• Verify that the printer is plugged into an outlet that provides the correct voltage and power. Review
the electrical specification of the printer with an electrician if necessary.
WARNING:
properly grounded. Electrical products can be hazardous if misused.
• Do not place the printer in an area where people can step on the power cord.
• Do not place objects on the power cord.
• Replace the power cord if it becomes frayed or worn.
8 Phaser 6000/6010 Color Printer
User Guide
Do not push objects, including paper clips or staples, into slots or
Avoid the potential of electrical shock by ensuring that the printer is