Table of Contents
Advertisement
4.
Adjust the rear stopper (3) and paper guides (4) to the size of paper being used.
For loading A4 or Legal size paper, push the lever in the arrow direction (b) and
extend the paper tray using the rear paper
5.
If required, set the correct media type in the Printer menu.
page 47.
To prevent paper jams:
>
Do not leave space between the paper and the guides and rear stopper.
>
Do not overfill the paper tray. Capacity depends on the type of paper stock.
>
Do not load damaged paper.
>
Do not load paper of different sizes or types at the same time.
>
Close the paper tray gently.
>
Do not pull the paper tray out during printing (except as described below for the
2nd tray).
NOTE
>
If you have two trays (optional second tray fitted) and you are printing
from the 1st (upper) tray, you can pull out the 2nd (lower) tray during
printing to reload it. However, if printing from the 2nd tray, do not pull out
the 1st tray. This will cause a paper jam.
>
For face down printing, make sure the face up (rear cover) stacker is
closed (the paper exits from the top of the MFP). Stacking capacity is
approximately 150 sheets, depending on paper weight.
>
For face up printing, make sure the face up (rear cover) stacker is open
Always use the face up (rear cover) stacker for heavy paper (card stock,
etc.).
Do not open or close the rear paper exit while printing as it may
result in a paper jam.
3
b
4
CAUTION!
Getting started > 28
stopper.
"Tray1 Config" on
Advertisement
Table of Contents
