GS748T Smart Switch Software Administration Manual
To configure LLDP-MED settings for a port:
1.
From the Port field, select the port to configure.
2.
From the LLDP-MED Status field, enable or disable the LLDP-MED mode for the selected
interface.
3.
From the Notification field, specify whether the port should send a topology change
notification if a device is connected or removed.
4.
From the Transmit Optional TLVs field, specify whether the port should transmit optional
type length values (TLVs) in the LLDP PDU frames. If enabled, the following LLDP-MED
TLVs are transmitted:
•
MED Capabilities
•
Network Policy
•
Location Identification
•
Extended Power via MDI: PSE
•
Extended Power via MDI: PD
•
Inventory
5.
Click Apply to send the updated configuration to the switch. These changes occur
immediately and the configuration will be saved.
6.
Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
Chapter 2: Configuring System Information
| 63