NETGEAR GS748Tv4 Software Administration Manual page 153

GS748T Smart Switch Software Administration Manual
• Click Clear Counters to clear the authentication server and RADIUS statistics to their
default values.
• Click Refresh to refresh the page with the most current data from the switch.
Accounting Server Configuration
Use the RADIUS Accounting Server Configuration page to view and configure various
settings for one or more RADIUS accounting servers on the network.
To access the RADIUS Accounting Server Configuration page, click Security >
Management Security > RADIUS > Accounting Server Configuration.
To configure the RADIUS accounting server:
1. In the Accounting Server Address field, specify the IP address of the RADIUS
accounting server to add.
2. In the Port field, specify the UDP port number the server uses to verify the RADIUS
accounting server authentication. The valid range is 0–65535.
3. From the Secret Configured menu, select Yes to add a RADIUS secret in the next field.
You must select Yes before you can configure the RADIUS secret. After you add the
RADIUS accounting server, this field indicates whether the shared secret for this server has
been configured.
4. In the Secret field, type the shared secret to use with the specified accounting server.
5. From the Accounting Mode menu, enable or disable the RADIUS accounting mode.
6. Click Apply to update the switch with the RADIUS Accounting server settings.
Chapter 5: Managing Device Security | 153