NETGEAR GS748Tv4 Software Administration Manual page 17

GS748T Smart Switch Software Administration Manual
WARNING!
When you change the IP address of your administrative system,
you will loose your connection to the rest of the network. Be sure
to write down your current network address settings before you
change them.
To modify the network settings on your administrative system:
1. On your PC, access the MS Windows operating system TCP/IP Properties.
2. Set the IP address of the administrative system to an address in the 192.168.0.0 network,
such as 192.168.0.200. The IP address must be different from that of the switch but within
the same subnet.
3. Click OK.
To configure a static address on the switch:
1. Use a straight-through cable to connect the Ethernet port on the administrative system
directly to any port on the GS748T.
2. Open a Web browser on your PC and connect to the management interface as described in
Web Access on page 18.
3. Change the network settings on the switch to match those of your network (this procedure is
described in IP Configuration on page 35
After you change the network settings on the switch, return the network configuration on your
administrative system to the original settings.
).
Chapter 1: Getting Started | 17