NETGEAR GS748Tv4 Software Administration Manual page 203

GS748T Smart Switch Software Administration Manual
Field
STP Mode
STP State
Admin Mode
LACP Mode
Physical Mode
Physical Status
Link Status
Link Trap
Packets RX and TX 64
Octets
Packets RX and TX 65-127
Octets
Packets RX and TX
128-255 Octets
Packets RX and TX
256-511 Octets
Description
Displays the Spanning Tree Protocol (STP) Administrative Mode for the port or
LAG. The possible values for this field are:
:
• Enable Enables the Spanning Tree Protocol for this port.
:
• Disable Disables the Spanning Tree Protocol for this port.
Displays the port's current state Spanning Tree state. This state controls what
action a port takes on receipt of a frame. If the bridge detects a malfunctioning
port it will place that port into the broken state. The other five states are
defined in IEEE 802.1D:
•
Disabled
• Blocking
• Listening
• Learning
• Forwarding
•
Broken
Displays the port control administration state:
•
Enable: The port can participate in the network (default).
•
Disable: The port is administratively down and does not participate in the
network.
Selects the Link Aggregation Control Protocol administration state:
•
Enable: Specifies that the port is allowed to participate in a port channel
(LAG), which is the default mode.
• Disable: Specifies that the port cannot participate in a port channel (LAG).
Indicates the port speed and duplex mode. In auto-negotiation mode, the
duplex mode and speed are set from the auto-negotiation process.
Indicates the port speed and duplex mode status.
Indicates whether the link is up or down.
This object determines whether or not to send a trap when link status
changes. The factory default is Enable.
•
Enable: Specifies that the system sends a trap when the link status
changes.
•
Disable: Specifies that the system does not send a trap when the link
status changes.
The total number of packets (including bad packets) received or transmitted
that were 64 octets in length (excluding framing bits but including FCS octets).
The total number of packets (including bad packets) received or transmitted
that were between 65 and 127 octets in length inclusive (excluding framing
bits but including FCS octets).
The total number of packets (including bad packets) received or transmitted
that were between 128 and 255 octets in length inclusive (excluding framing
bits but including FCS octets).
The total number of packets (including bad packets) received or transmitted
that were between 256 and 511 octets in length inclusive (excluding framing
bits but including FCS octets).
Chapter 6: Monitoring the System | 203