Gs752Ts Front-Panel And Back-Panel Configuration - NETGEAR GS728TS Hardware Installation Manual

GS728TS, GS728TPS, GS752TS, and GS752TPS Smart Switch Hardware Installation Guide

GS752TS Front-Panel and Back-Panel Configuration

The GS752TS Smart Switch has 48 10/100/1000 Mbps copper ports and 6 SFP fiber ports, 2
of which are combo ports. Up to two SFP ports (port 51 and 52) at a time can be used as
stacking ports.
Each port is capable of sensing the line speed and negotiating the duplex mode with the link
partner automatically.
Figure 6 illustrates the front panel of the NETGEAR GS752TS Smart Switch.
Power, Fan, and
Stack Master LEDs
Stack ID LED
Factory
Defaults Button
Reset Button
Figure 6. GS752TS Front Panel
The front panel contains the following:
• 48 RJ-45 connectors for 10/100/1000 Mbps autosensing Gigabit Ethernet switching ports
• 2 dedicated SFP ports (port 49 and 50) to support 1G optical module
• 2 dedicated SFP ports (port 51 and 52) to support 1G optical module (uplink) or 2.5G
stacking (via stacking cable).
• Up to two of these ports (ports 51 and 52) can alternatively be used as stacking ports
• Reset button to restart the device
• Recessed default reset button to restore the device back to the factory defaults
• Link, Speed, and Activity LEDs for each port
• Power, Fan Status, Stack Master, and Stack ID LEDs
Figure 7 illustrates the NETGEAR GS752TS Smart Switch back panel.
Figure 7. GS752TS Back Panel
The back panel contains a power connector.
Link/Speed/ACT LEDs
10/100/1000M Ethernet Ports
Combo and Dedicated
SFP Ports
Power Connector
Chapter 2. Physical Description | 15