GS728TS, GS728TPS, GS752TS, and GS752TPS Smart Switch Hardware Installation Guide
4.
Align the mounting holes in the brackets with the holes in the rack, and insert two pan-head
screws with nylon washers through each bracket and into the rack.
5.
Tighten the screws with a #2 Phillips screwdriver to secure mounting brackets to the rack.
Figure 12. Rack Mount
Step 3: Checking the Installation
Before applying power to the switch, perform the following steps:
•
Inspect the equipment thoroughly.
•
Verify that all cables are installed correctly.
•
Check cable routing to make sure cables are not damaged or creating a safety hazard.
•
Ensure all equipment is mounted properly and securely.
Step 4: Connecting Devices to the Switch
The following procedure describes how to connect PCs to the switch's RJ-45 ports. The
GS728TS, GS728TPS, GS752TS, and GS752TPS Smart Switch contains Auto Uplink
technology, which allows the attaching of devices using either straight-through or crossover
cables.
26 |
Chapter 4. Installation