Port Setting - NETGEAR GS724TPS - ProSafe - Gigabit Stackable PoE Smart Switch Software Administration Manual

GS700TPS Smart Switch Software Administration Manual
• Class of Service – Select the CoS tag to add to incoming packets not containing a VPT
received on the Voice VLAN. The possible field values are 0-7, where zero is the lowest
priority, and seven is the highest priority.
• Remark CoS – Enable or disable reassigning the CoS tag value to packets received on the
Voice VLAN. The possible field values are:
– Disable – Disables remarking the packet CoS tag value. This is the default value.
– Enable – Enables remarking the packet CoS tag value.
• Voice VLAN Aging Time – Enter the Voice VLAN aging time. The Voice VLAN aging
time sets the maximum inactivity time for a Voice VLAN port member after its MAC
Address is aged out. If the time since the last MAC Address with telephony MAC Address
was aged out exceeds the Voice VLAN aging time, the port is dropped from the Voice
VLAN. The default time is one day. The field format is Day, Hour, Minute. The Voice
VLAN aging time starts after the MAC Address is aged out from the Dynamic MAC
Address table. The MAC Address dynamic aging default time is 300 sec. For more
information on defining MAC address age out time, see
2. Select the device VoiceVLAN Status in the provided field.
3. If you selected Enable in the VoiceVLAN Status field, select the VoiceVLAN ID, Class of
Service, Remark CoS and enter the Voice VLAN Aging Time in the provided fields.
4. Click APPLY to update the device.

Port Setting

The Voice VLAN Port Setting screen allows network managers to add ports or LAGs to the Voice
VLAN.
To add ports or LAGs to the Voice VLAN:
1. Click Switching > Voice VLAN > Advanced > Port Setting. The Voice VLAN Port Setting
screen opens:
4-25
v1.0, June 2009
"Dynamic Addresses".
Configuring Switching Settings