Log Filter - NETGEAR GS724TPS - ProSafe - Gigabit Stackable PoE Smart Switch Software Administration Manual

GS700TPS Smart Switch Software Administration Manual
– Enable – Enables device logs. This is the default value.
2. Select either Enable or Disable as the Logging State in the provided field.
3. Click APPLY to update the device.

Log Filter

The Log Filter screen contains fields for defining which events are recorded to which logs. Log
messages are listed from the highest severity to the lowest severity level.
To configure log filters:
1. Click Monitoring > Logs > Log Filter. The Log Filter screen displays:
Figure 7-2
The Log Filter screen contains the following fields:
• RAM Logs – Select the minimum message severity level to appear in the RAM Log. The
following are the available message severity levels:
– Emergency – Indicates the system is not functioning. Emergency is the highest
warning level. If the system is down or not functioning properly, an emergency log
message is saved to the specified logging location.
– Alert – Indicates the system needs immediate attention. Alert is the second highest
warning level. An alert log is saved, if there is a serious device malfunction; for
example, all device features are down.
– Critical – Indicates the system is in a critical state. Critical is the third highest warning
level. A critical log is saved if a critical device malfunction occurs; for example, two
device ports are not functioning, while the rest of the device ports remain functional.
– Error – Indicates a system error has occurred; for example, if a single port is offline.
7-3
v1.0, June 2009
Monitoring the Switch