Protected Ports - NETGEAR GS724TPS - ProSafe - Gigabit Stackable PoE Smart Switch Software Administration Manual

GS700TPS Smart Switch Software Administration Manual
• Max Entries – Enter the maximum number of MAC addresses that can be learned on the
port. The Max Entries field is enabled only if the Limited Dynamic Lock mode is selected.
The range is 1-128 entries. The default value is 1.
• Action – Select the action to be applied to packets arriving on a locked port. The possible
field values are:
– Forward – Forwards packets from an unknown source without learning the MAC
address.
– Discard – Discards packets from any unlearned source. This is the default value.
– Shutdown – Discards packets from any unlearned source and shut down the port. The
port remains shut down until reactivated or until the device is reset.
• Trap – Select whether traps are enabled or disabled when a packet from an unknown
source is received on a locked port. The possible field values are:
– Enable – Enables traps.
– Disable – Disables traps. This is the default value.
• Trap Frequency – Enter the frequency at which traps are sent. The field format is in
seconds. The range is 1-1,000,000. The default value is 10 seconds.
2. Select the port security Status, Learning Mode, Action and Trap status from the lists in the
provided fields in the first row.
3. Enter the Max Entries and Trap Frequency in the provided fields in the first row.
4. Click APPLY to update the device.

Protected Ports

The Protected Ports Membership screen allows network managers to define protected port
membership. Protected ports isolates Layer 2 traffic between interfaces that share the same
Broadcast domain. The isolated ports are defined as protected ports and can forward traffic to
6-19
v1.0, June 2009
Managing Security