Universal Battery Charger (Ubc) Adapter; Inserting And Removing A Battery; Battery Charging Indicators - Motorola MC9094-KUCHJERA6WR - MC9094-K - Win Mobile 6.1 Professional 624 MHz User Manual

6 - 18 MC909X User Guide

Universal Battery Charger (UBC) Adapter

This section describes how to use the UBC adapter to charge a spare battery.
The UBC can be used with a power supply as a standalone spare battery charger or it can be used with the
four station UBC2000 to provide charging to simultaneously charge up to four spare batteries. For additional
information about the UBC2000, see the UBC 2000 Universal Battery Charger Product Guide (p/n
70-33188-xx).
Battery Release
Battery Well
UBC Adapter
Figure 6-18

Inserting and Removing a Battery

Insert the battery into the battery well with the charging contacts facing down (over charging pins) and gently
press down on the battery to ensure proper contact.
To remove the battery, press the battery release and lift battery out of the well.
CAUTION

Battery Charging Indicators

To charge a spare battery using the UBC adapter, connect the power supply to the UBC, then insert the spare
battery. The spare battery begins charging automatically.
The UBC's charge LEDs (see
shows battery charging status indications.
The battery usually charges in three hours.
Battery
Use only a Symbol approved power supply output rated 15 VDC and minimum 1.5 A. Use of an
alternative power supply will void the product warranty and may cause product damage. See
Appendix C, Regulatory for the power supply regulatory compliance statement.
Figure 6-19) show the status of the battery charging in the adapter.
UBC Adapter
POWER
READY or STANDBY or FAULT
(Green) (Flashing Yellow) (Solid Yellow)
CHARGING
(Solid Yellow)
Table 6-1