Front I/O, USB Assembly
The front I/O, USB assembly is mounted to the front of the chassis and is removed by pulling it away
from the chassis.
1.
Prepare the computer for disassembly
2.
Remove the computer access panel
3.
Remove the front bezel
4.
Disconnect the three cables from the following system board connectors:
●
Yellow connector labeled FRONT USB
●
Green connector labeled FRONT USB2
●
Blue connector labeled FRONT AUD
NOTE:
used for the front I/O assembly. See the image below for its location.
5.
Remove the screw that secures the assembly to the front of the chassis (1).
6.
Rotate the right side of the assembly away from the chassis, and then pull the assembly toward
the right and away from the chassis (2) while threading the wires through the slot between the
drive cage and chassis front and the hole in the front of the chassis.
Figure 6-47
To reinstall the assembly, reverse the removal procedure.
(Front Bezel on page
The blue FRONT AUD connector is not located near the other two connectors
Removing the front I/O, USB assembly
(Preparation for Disassembly on page
(Computer Access Panel on page
44).
35).
43).
Front I/O, USB Assembly
73