Table E-13
Solving Memory Problems (continued)
Insufficient memory error during operation.
Cause
Too many Terminate and Stay Resident programs (TSRs)
are installed.
You have run out of memory for the application.
Power LED flashes Red five times, once every second, followed by a two second pause, and the computer beeps
five times. (Beeps stop after fifth iteration but LEDs continue flashing.)
Cause
Memory is installed incorrectly or is bad.
202 Appendix E Troubleshooting Without Diagnostics
Solution
Delete any TSRs that you do not need.
Check the memory requirements for the application or add
more memory to the computer.
Solution
1.
Reseat DIMMs. Power on the system.
2.
Make sure a DIMM is installed in the black DIMM
connector first if there is only one DIMM in the system.
3.
Replace third-party memory with HP memory.
4.
Replace the system board.