Processor
1.
Prepare the computer for disassembly
2.
Remove the computer access panel
3.
Remove the heat sink
4.
Rotate the locking lever to its full open position (1).
5.
Raise and rotate the microprocessor retainer to its fully open position (2).
6.
Carefully lift the processor from the socket (3).
CAUTION:
handling them could cause irreparable damage. Once pins are damaged it may be necessary to
replace the system board.
The heat sink must be installed within 24 hours of installing the processor to prevent damage to
the processor's solder connections.
Figure 7-60
NOTE:
138 Chapter 7 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
(Heat sink on page
Do NOT handle the pins in the processor socket. These pins are very fragile and
Removing the processor
System board appearance may vary.
(Preparation for Disassembly on page
(Computer Access Panel on page
77).
35).
43).