Gps Data Files - Eagle FishStrike 2000 Installation And Operation Instructions Manual

NOTE:
To load a Navionics

GPS Data files:

GPS Data Files contain waypoints, routes, trails and event marker
icons. Instructions for copying GPS Data Files between your computer
and a MMC are contained in the instruction manual for your MMC
card reader and MapCreate 6 software.
GPS data automatically recorded in the unit's internal memory must be
saved to the MMC as a GPS Data File in order to store it on your
personal computer. GPS Data Files stored on a MMC must be copied
from the card to the unit's internal memory before the unit can read
them. Here's how:
1. Insert the MMC into your unit. Press
↓
| | to
S ENT
ETUP
The Transfer My Data submenu asks if you want to save data to the
MMC or load data from the MMC into the unit's memory.
2. The Transfer My Data menu includes a message that tells you if a
MMC is present or not. If no MMC is present, you must insert a card
into the unit to activate the Load or Save commands.
To transfer data from the unit to the MMC: press
To transfer data from the MMC to the unit: press
3. Saving to MMC: To accept the default name "Data" for the GPS
Data File, press ↓ to
shown in the following figures), press
box. Press ↑ or ↓ to change the first character, then press
character and repeat until the name is correct. Then, press
|
S D ENT
AVE ATA

chart, see Sec. 8 for the Navionics Charts entry.
T M D
RANSFER Y
S D
AVE ATA
.
| and the screen below appears.
ENT
ATA
| . If you want to rename the file (as
ENT
to activate the Data selection
ENT
115
| |
MENU MENU
ENT
→
to
→
↓
to
S
YSTEM
(for .)
S
AVE
| .
L ENT
OAD
to the next
↓
| to
ENT