Simulating Trail Or Route Navigation - Eagle FishStrike 2000 Installation And Operation Instructions Manual

waypoint, map place or POI location (
steer your position and change speed on the map by using the arrow keys
(
S A
TEER WITH RROWS
dialog boxes provided on the simulator menu screen.
To get to the GPS Simulator:
1. Press
MENU
2. Press ↓ to
GPS S
GPS Setup Menu (left); GPS Simulator menu (right).
Choose the desired settings, then turn the simulator on by highlighting
the
GPS S
IMULATOR
close this menu. A message and tone appear periodically, warning you
the simulator is on. To turn the simulator off, repeat the above steps or
turn off the unit.
While in simulator mode and using the
can press
EXIT
This will allow you to use the map cursor during a simulation. To turn
steering and speed boxes back on again, return to the GPS Simulator
menu. Select the

Simulating Trail or Route Navigation

In Simulator mode, your unit can automatically follow a trail or route
without manual steering if you use these steps:
1. From the Map Page, go to the simulator menu. Pick a
at or near the beginning of your trail/route. Enter an
P
OSITION
approximate
toward the start of the trail/route.
2. Set to zero. Select
S
PEED
which turns on the simulator and returns you to the Map Page
3. Begin navigating along the trail/route. (If you are close enough to the
first waypoint, the arrival alarm will usually go off as soon as
command) or by setting the track and speed in the
| |↓ to
MENU GPS S
|
IMULATOR
box and pressing
O
N
to clear the steering and speed boxes from the screen.
S A
TEER WITH
(shown in compass degrees) that will point you
T
RACK
C
HOOSE
|
ENT
ETUP
. The GPS Simulator Menu appears.
ENT
ENT
S
TEER WITH
command, press
RROWS
S A
TEER WITH RROWS
136
command). You can
S
TART
.
. Press
EXIT
A
RROWS
ENT,
command and press
| | to
EXIT EXIT
command, you
then .
EXIT
S
TARTING
ENT,
.