Alliance Laundry Systems 120 Pound Capacity Operating & Maintenance Manual
Alliance Laundry Systems 120 Pound Capacity Operating & Maintenance Manual

Alliance Laundry Systems 120 Pound Capacity Operating & Maintenance Manual

Drying tumblers 120/170 pound capacity

Advertisement

Drying Tumblers
NOTA: Para bajar una
copia de estas
instrucciones en
español, visite
www.comlaundry.com.
Keep These Instructions for Future Reference.
(If this machine changes ownership, this manual must accompany machine.)
120 Pound Capacity
170 Pound Capacity
Refer to Page 3 for Model Identification
www.comlaundry.com
Part No. 70283501R6
August 2007

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 120 Pound Capacity and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Alliance Laundry Systems 120 Pound Capacity

  • Page 1 NOTA: Para bajar una copia de estas instrucciones en español, visite www.comlaundry.com. Keep These Instructions for Future Reference. (If this machine changes ownership, this manual must accompany machine.) 120 Pound Capacity 170 Pound Capacity www.comlaundry.com Part No. 70283501R6 August 2007...
  • Page 3 These instructions must be posted in a prominent location. Step-by-step instructions of the above safety information must be posted in a prominent location near the tumbler for customer use. 70283501 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT MISE EN GARDE POUR VOTRE SÉCURITÉ, les informations de ce guide doivent être respectées afin de...
  • Page 4: Table Of Contents

    All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any means without the expressed written consent of the publisher. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Introduction...
  • Page 5: Model Identification

    Alliance Laundry Systems at (920) 748-3950 for the name and address of the nearest authorized parts distributor. For technical assistance, call (920) 748-3121. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 70283501 Introduction SU120L XU120L...
  • Page 6: Serial Plate Location

    Model and serial numbers are found on serial plate on rear of machine. Refer to Figure 1. TMB1298N 120 POUND TUMBLER 170 POUND TUMBLER TMB1298N Serial Plate Figure 1 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 70283501...
  • Page 7: Explanation Of Safety Messages

    NOTE: The word “NOTE” is used to communicate installation, operation, maintenance or servicing information that is important but not hazard related. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 70283501 IMPORTANT: Warranty is void unless tumbler is installed according to instructions in the Installation Manual.
  • Page 8: Important Safety Instructions

    © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 10. Do not use fabric softeners or products to eliminate static unless recommended by the manufacturer of the fabric softener or product.
  • Page 9 If they are dried, wipe out the cylinder with a damp cloth to remove particles of fiberglass. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 70283501 26. Always follow the fabric care instructions supplied by the garment manufacturer.
  • Page 10: Emergency Stop Button On Ce Models

    NOTE: Activation of the emergency stop button stops all machine control circuit functions, but DOES NOT remove all electrical power from machine. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Operation WARNING Operating Instructions Step 1: Clean Lint Screen/Compartment Remove any accumulated lint from the lint screen and compartment.
  • Page 11: Control Instructions

    5. Press the PUSH TO START button in and hold it in for approximately three seconds. This starts the tumbler cycle. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 70283501 REVERSING MODELS Figure 3...
  • Page 12: Electronic Opl Control

    NOTE: Do not press directly on lights or the center of pad. For proper selection, press on pad slightly to the right of center. Refer to Figure 5. Figure 5 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT STATUS HIGH START...
  • Page 13: Reversing Operation

    © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 70283501 IMPORTANT: After any electrical maintenance is done, make sure that the blower motor is turning counterclockwise.
  • Page 14: Dual Digital Timer Control

    © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Figure 6 IMPORTANT: To stop the tumbler at any time during the cycle, OPEN DOOR.
  • Page 15 AF - 1 started Airflow switch failed to close after AF - 2 cycle started © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 70283501 WARNING Definition • Check thermistor. Replace if inoperative. • Check wiring diagram between control and thermistor.
  • Page 16: Ignition Control Operation

    The ignition control will remain in Run Mode until 24VAC is removed from terminals TH and GND on the control. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Termination of Flame The flame will go out when power is removed from ignition control.
  • Page 17: Gas Valve

    Fast Red and Orange Flashes Diagnostic (DGN) LED Figure 8 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 70283501 Diagnostic LED (DGN LED) / Error Codes The Diagnostic LED or DGN LED is located by the power connector on the ignition control.
  • Page 18: Maintenance

    A torn lint screen allows lint to pass from the tumbler to the ductwork system and may restrict airflow. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Maintenance WARNING d. The lint screen is designed to completely cover the entire opening in the lint screen panel.
  • Page 19: Bi-Annually

    3. Check and clean steam coils, if applicable. 4. Check flow of combustion and ventilation air. 5. Check belt tension and condition. Replace worn or cracked belts. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 70283501 WARNING Bi-Annually 1.
  • Page 20 Lint buildup will act as an insulator, causing machine to overheat. Clean lint and debris buildup from blower to maintain proper airflow, to avoid overheating and prevent possible vibration. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT WARNING W002 70283501...
  • Page 21 Check cylinder and front panel seals. Inspect cabinet and inner panels for any damage, replace or repair as needed. Clean burner tubes of any lint buildup. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 70283501 WARNING Maintenance...
  • Page 22: Copyright, Alliance Laundry Systems Llc – Do Not Copy Or Transmit

    For technical assistance, call (920) 748-3121. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Possible Reason – Corrective Actions Insert correct coin(s) or valid card if applicable.

Table of Contents

Save PDF