Alliance Laundry Systems 30 Series Operation & Maintenance Manual
Alliance Laundry Systems 30 Series Operation & Maintenance Manual

Alliance Laundry Systems 30 Series Operation & Maintenance Manual

Advertisement

Tumble Dryers
Huebsch
18 Digit Model Numbers with 6 in 13th Position
Refer to Page 9 for Model Identification
Original Instructions
Keep These Instructions for Future Reference.
CAUTION: Read the instructions before using the machine.
(If this machine changes ownership, this manual must accompany machine.)
Part No. 70693401ENR4
www.alliancelaundry.com
March 2024

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 30 Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Alliance Laundry Systems 30 Series

  • Page 1 Tumble Dryers Huebsch 18 Digit Model Numbers with 6 in 13th Position Refer to Page 9 for Model Identification Original Instructions Keep These Instructions for Future Reference. CAUTION: Read the instructions before using the machine. (If this machine changes ownership, this manual must accompany machine.) Part No.
  • Page 3 IMPORTANT: The tumble dryer is not to be used if in- dustrial chemicals have been used for cleaning. Units are IPx4 when enclosed per these instructions. © Copyright, Alliance Laundry Systems LLC - Part No. 70693401ENR4 DO NOT COPY or TRANSMIT...
  • Page 4 • DO NOT let children play on or in the dryer. W931 To reduce the risk of serious injury: Avoid contact with hot surfaces. W927 © Copyright, Alliance Laundry Systems LLC - Part No. 70693401ENR4 DO NOT COPY or TRANSMIT...
  • Page 5 The following information applies to the state of Massachusetts, USA. • This appliance can only be installed by a Massachusetts li- censed plumber or gas fitter. © Copyright, Alliance Laundry Systems LLC - Part No. 70693401ENR4 DO NOT COPY or TRANSMIT...
  • Page 6: Safety Information

    © Copyright, Alliance Laundry Systems LLC - Part No. 70693401ENR4 DO NOT COPY or TRANSMIT...
  • Page 7: Explanation Of Safety Instruction Messages

    Always contact your dealer, distributor, service agent or the man- ufacturer about any problems or conditions you do not under- stand. © Copyright, Alliance Laundry Systems LLC - Part No. 70693401ENR4 DO NOT COPY or TRANSMIT...
  • Page 8: Table Of Contents

    Disposal of Unit..................28 © Copyright 2024, Alliance Laundry Systems LLC All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any means without the expressed written consent of the publisher.
  • Page 9: Introduction

    Introduction Introduction Machine Identification Information in this manual is applicable to these machines. Refer to the serial plate. 30 Series (30 lb / 13 Kg) HA030E HG030E HH030L HJ030N HK030N HT030D HT030N HU030L HA030L HG030L HH030N HK030E HL030E HT030E HU030E...
  • Page 10 200 Series (200 lb / 90 Kg) HA200L HG200L HH200L HJ200L HK200L HT200L HT200S HU200N HA200N HG200N HH200N HJ200N HK200N HT200N HU200L HU200S HA200S HG200S HH200S HJ200S HT200C © Copyright, Alliance Laundry Systems LLC - Part No. 70693401ENR4 DO NOT COPY or TRANSMIT...
  • Page 11 Control Digit (position 7) Actuation Digit (position 8) nation F - Dual Digital Control N - OPL FN- Dual Digital Control, OPL N - Galaxy NN- Galaxy, OPL © Copyright, Alliance Laundry Systems LLC - Part No. 70693401ENR4 DO NOT COPY or TRANSMIT...
  • Page 12: Contact Information

    If replacement parts are required, contact the source from where you purchased your unit or call +1 (920) 748-3950 for the name and address of the nearest authorized parts distributor. © Copyright, Alliance Laundry Systems LLC - Part No. 70693401ENR4 DO NOT COPY or TRANSMIT...
  • Page 13 Introduction 30, T30, 35, T45, 55 Series TMB2721N_SVG 50, 75 Series TMB2707N_SVG 120, 170, 200 Series 170/200 TMB2734N_SVG 1. Serial Plate Figure 1 © Copyright, Alliance Laundry Systems LLC - Part No. 70693401ENR4 DO NOT COPY or TRANSMIT...
  • Page 14: Operating Instructions

    START pad or button. NOTE: Activation of the emergency stop button stops all machine control circuit functions, but DOES NOT remove all electrical power from ma- chine. © Copyright, Alliance Laundry Systems LLC - Part No. 70693401ENR4 DO NOT COPY or TRANSMIT...
  • Page 15: Reversing Operation

    (as mum drying load is: viewed from the front of the tumble dryer). If cylinder is rotating © Copyright, Alliance Laundry Systems LLC - Part No. 70693401ENR4 DO NOT COPY or TRANSMIT...
  • Page 16: Control Instructions

    Temperature 180°F [82°C] heat is dissipated. Temperature 160°F [72°C] W756 DELICATES Temperature 130°F [54°C] © Copyright, Alliance Laundry Systems LLC - Part No. 70693401ENR4 DO NOT COPY or TRANSMIT...
  • Page 17: Galaxy (Opl)

    After an hour, the machine enters extended tumble and will tumble for two minutes every hour for up to 18 hours or until the door is opened. © Copyright, Alliance Laundry Systems LLC - Part No. 70693401ENR4 DO NOT COPY or TRANSMIT...
  • Page 18: Galaxy Touch Vend Control

    NOTE: The LED will flash on for 1/4 second, then off for 1/4 second during a fault condition. The pause between fault codes is 3 seconds. © Copyright, Alliance Laundry Systems LLC - Part No. 70693401ENR4 DO NOT COPY or TRANSMIT...
  • Page 19: Internal Control Failure

    [1.2 cm] above the base of the flame. Refer to Figure 7 . Proper location of the electrode assembly is important for optimal system performance. The electrode assembly should be located © Copyright, Alliance Laundry Systems LLC - Part No. 70693401ENR4 DO NOT COPY or TRANSMIT...
  • Page 20: Flame Current Measurement

    1.0 VDC, so a reading of 2.6 VDC would equate to 2.6 micro-amps. A good burner ground that matches the control ground is critical for reliable flame sensing. © Copyright, Alliance Laundry Systems LLC - Part No. 70693401ENR4 DO NOT COPY or TRANSMIT...
  • Page 21: Maintenance

    3. Remove lint filter and thoroughly vacuum exhaust duct. a. A lazy yellow tipped flame indicates a lack of air. b. A harsh, roaring, very blue flame indicates too much air. © Copyright, Alliance Laundry Systems LLC - Part No. 70693401ENR4 DO NOT COPY or TRANSMIT...
  • Page 22: Procapture Maintenance

    However, replacement or removal of the lint sensor re- TMB2749N_SVG quires the machine be powered down for a service Figure 12 task. NOTE: Loading door should be closed before cleaning out lint. © Copyright, Alliance Laundry Systems LLC - Part No. 70693401ENR4 DO NOT COPY or TRANSMIT...
  • Page 23: Fire Suppression System (Optional Equipment) Maintenance Test

    CAUTION Clean up any water spilled during testing to avoid personal injury. W487 © Copyright, Alliance Laundry Systems LLC - Part No. 70693401ENR4 DO NOT COPY or TRANSMIT...
  • Page 24 15. On maintenance record, check box if fire suppression system the maintenance test, DO NOT operate the tumble passed the test, date and sign record. dryer. © Copyright, Alliance Laundry Systems LLC - Part No. 70693401ENR4 DO NOT COPY or TRANSMIT...
  • Page 25 Maintenance TMB2010N_SVG 1. Spray Manifold 2. Water Spray Figure 18 © Copyright, Alliance Laundry Systems LLC - Part No. 70693401ENR4 DO NOT COPY or TRANSMIT...
  • Page 26: Before You Call For Service

    • • Exhaust duct to outside is blocked. Clean out. • ProCapture models - lint compartment full. Clean lint compartment and clear prompt on control. © Copyright, Alliance Laundry Systems LLC - Part No. 70693401ENR4 DO NOT COPY or TRANSMIT...
  • Page 27: Removing Tumble Dryer From Service

    3. Turn off manual gas shut-off valve on machine. 4. Turn off steam supply external to machine. 5. Remove all electric, gas and steam connections. © Copyright, Alliance Laundry Systems LLC - Part No. 70693401ENR4 DO NOT COPY or TRANSMIT...
  • Page 28: Disposal Of Unit

    MIX1N_SVG Figure 19 © Copyright, Alliance Laundry Systems LLC - Part No. 70693401ENR4 DO NOT COPY or TRANSMIT...

This manual is also suitable for:

T30 series35 seriesT45 series50 series55 series75 series ... Show all

Table of Contents