Table of Contents
Advertisement
• You use incorrect cookware. The symbol
comes on and the cooking zone de-
activates automatically after 2 minutes.
• You do not deactivate a cooking zone or
change the heat setting. After some time
comes on and the appliance deacti-
vates. See below.
• The relation between heat setting and
times of the Automatic Switch Off func-
tion:
•
,
-
— 6 hours
•
-
— 5 hours
•
-
— 4 hours
•
-
— 1.5 hours
3.3 The heat setting
Touch the control bar at the heat setting.
Change to the left or the right, if it is neces-
sary. Do not release before you have a cor-
rect heat setting. The display shows the
heat setting.
0
3 5
3.4 Bridge function
The Bridge function connects two cooking
zones and they operate as one.
First set the heat setting for one of the
cooking zone.
To activate the Bridge function touch
To set or change the heat setting touch
one of the control sensors.
To deactivate the Bridge function touch
. The cooking zones operate independent-
ly.
When you use only one zone cooking zone
of the pair we recommend that you use the
rear cooking zone. Also when you use
large cookware we recommend that you
put it near to the rear cooking zone.
3.5 Automatic Heat Up
You can get a necessary heat setting in a
shorter time if you activate the Automatic
8 10
14 P
.
Heat Up function. This function sets the
highest heat setting for some time (see the
diagram), and then decreases to the nec-
essary heat setting.
To start the Automatic Heat Up function for
a cooking zone:
1.
Touch
(
comes on in the dis-
play).
2.
Immediately touch the necessary heat
setting. After 3 seconds
in the display.
To stop the function change the heat set-
ting.
12
11
10
9
8
7
6
5
4
3
2
1
0
1
2 3 4 5 6 7 8 9 10 11 12 13 14
3.6 Power function
The Power function makes more power
available to the induction cooking zones.
The Power function can be activated for a
limited period of time ( see Technical infor-
mation chapter). After that, the induction
cooking zone automatically sets back to
highest heat setting. To activate, touch
comes on. To deactivate, change the
heat setting.
3.7 Power management
The power management divides the power
between two cooking zones in a pair (see
the illustration). The power function increa-
ses the power to the maximum level for
one cooking zone in the pair. The power in
the second cooking zone automatically de-
creases. The heat setting display for the re-
duced zone changes between two levels.
ENGLISH
7
comes on
,
Advertisement
Table of Contents
