Table of Contents
Advertisement
Problem
The residual heat indicator
does not come on.
The Automatic Heat Up
function does not operate.
The heat setting changes
between two levels.
The sensor fields become
hot.
There is no signal when
you touch the panel sen-
sor fields.
comes on.
comes on.
comes on.
and a number come
on.
comes on.
Possible
The cooking zone is not
hot because it operated
only for a short time.
The cooking zone is hot.
The highest heat setting is
set.
The Power management
is activated.
The cookware is too large
or you put it too near to
the controls.
The signals are deactiva-
ted.
The Automatic Switch Off
operates.
The Child Safety Device or
the Lock function oper-
ates.
No cookware is on the
cooking zone.
The cookware is incorrect. Use the correct cookware.
The diameter of the bot-
tom of the cookware is
too small for the cooking
zone.
The cookware does not
cover the square.
There is an error in the ap-
pliance.
The electrical connection
is incorrect. The supply
voltage is out of range.
ENGLISH
Remedy
If the cooking zone oper-
ated sufficiently long to be
hot, speak to the service
centre.
Let the cooking zone be-
come sufficiently cool.
The highest heat setting
has the same power as
the Automatic Heat Up
function.
Refer to "Power manage-
ment".
Put large cookware on the
rear cooking zones if nec-
essary.
Activate the signals (refer
to "OffSound control").
Deactivate the appliance
and activate it again.
Refer to the chapter "Op-
erating instructions".
Put cookware on the
cooking zone.
Use cookware with cor-
rect dimensions.
Cover the square fully.
Disconnect the appliance
from the electrical supply
for some time. Disconnect
the fuse from the electrical
system of the house. Con-
nect it again. If
comes
on again, speak to the
service centre.
Speak to a qualified elec-
trician to check the instal-
lation.
13
Advertisement
Table of Contents
