Table of Contents
Advertisement
Select CC to run a consistency check on this virtual drive.
•
Before you change a virtual drive configuration, back up any data on the virtual
drive that you want to save.
Select Adv Opers to set the advanced operations on this virtual drive.
•
Select either Change RAID
1.
Level or Change RAID Level
and Add Drive.
◊ If you select Change RAID
Level, change the RAID level
from the drop-down menu.
◊ If you select Change RAID
Level and Add Drive, change
the RAID level from the drop-
down menu and then select
one or more drives to add from
the list of drives.
Click Go. When the message appears, confirm that you want to migrate
2.
the RAID level of the virtual drive.
A reconstruction operation begins on the virtual drive. You must wait until
the reconstruction is completed before you perform any other tasks in
the WebBIOS CU.
Select Expand to increase the size of a virtual drive to occupy the remaining
•
capacity in a drive group. In addition, you can add drives to the virtual drive in
order to increase capacity.
1.
Enter the percentage of the
available capacity that you
want the virtual drive to use.
For example, if there are 100
GB of capacity available and
you want to increase the size
of the virtual drive by 30GB,
select 30 percent.
Click Calculate to determine
2.
the capacity of the virtual drive
after expansion. Click Ok.
The virtual drive expands by the selected percentage of the available
capacity.
ASUS PIKE 2108
2-33
Advertisement
Table of Contents
