Table of Contents
Advertisement
Using Manual Configuration: RAID 6
RAID 6 is similar to RAID 5 (drive striping and distributed parity), except that
instead of one parity block per stripe, there are two. With two independent parity
blocks, RAID 6 can survive the loss of two drives in a virtual drive without losing
data. Use RAID 6 for data that requires a very high level of protection from loss.
RAID 6 is best suited for networks that perform a lot of small input/output (I/O)
transactions simultaneously. It provides data redundancy, high read rates, and
good performance in most environments.
In the case of a failure of one drive or two drives in a virtual drive, the RAID
controller uses the parity blocks to recreate all of the missing information. If two
drives in a RAID 6 virtual drive fail, two drive rebuilds are required, one for each
drive. These rebuilds do not occur at the same time. The controller rebuilds one
failed drive, and then the other failed drive.
When you select Manual Configuration and click Next, the Drive Group Definition
screen appears. You use this screen to select drives to create drive groups.
1.
Hold <Ctrl> while you select at least three ready drives in the Drives panel on
the left.
Click Add To Arrary to move the drives to a proposed drive group
2.
configuration in the Drive Groups panel on the right.
Select a preferred Power save mode. The power save mode can be Max,
3.
Max without cache, Auto, None, and Controller defined. If you need to
undo the changes, click the Reclaim button.
When you have finished selecting drives for the drive group, click Accept
4.
DG.
Click Next. The Span Definition screen appears. Select one of the available
5.
drive groups, and then click Add to SPAN.
When finish, click Next. The Virtual Drive Definition screen appears. You
6.
use this screen to select the RAID level, strip size, read policy, and other
attributes for the new virtual drives.
7.
Change the virtual drive options from the defaults listed on the screen as
needed.
Here are brief explanations of the virtual disk options:
RAID Level: The drop-down menu lists the possible RAID levels for the
•
virtual drive. Select RAID 6.
Strip Size: The strip size specifies the size of the segment written to
•
each disk in a RAID configuration. You can set the strip size up to 64 KB.
A larger strip size produces higher read performance. If your computer
regularly performs random read requests, choose a smaller strip size.
The default is 64 KB.
ASUS PIKE 2108
2-23
Advertisement
Table of Contents
