Installation
instructions
Water
connection
(Steam
Model
only}
.
2.
Turn off COLD water supply to washer,
Remove COLD inlet hose from COLD water
supply and inspect for rubber washer. Replace
washer if it is torn or worn out.
RUBBER WASHER
MUST BEPRESENT
AND UNDAMAGED
J
COLD INLET HOSE
TO WASHER
3.
Momentarily turn on COLD supply and run
some water into a bucket or container to clear
any contaminants
in the line.
4.
Remove hose kit from dryer drum and inspect
hose couplings for proper placement of rubber
washers.
J
\
RUBBER WASHERS
MUST BE PRESENT