installation
instructions
3-wire
receptacle
'
(NEMA type 10-30R)
ELECTRICAL
SHOCK HAZARD
Failure to disconnect power source before servicing
could result in personal injury or even death.
-_
__
\
30 AMP
-
'
\
',, ,_
NEMA 10-30
_-
Neutral
_,,
-: :
/(center
wire)
1•
2.
•
4,
•
Turn off power supply to outlet•
Remove the screw securing the terminal block
access cover in the lower corner on the back of
the dryer.
Install a UUapproved
strain relief according
to the power cord/strain relief manufacturer's
instructions
in the power cord entry hole below
the access panel• At this time, the strain relief
should be loosely in place.
Thread an UNPLUGGED, UL-approved, 30 amp•
power cord, NEMA 10-30 type SRDT, through the
strain relief•
Attach the power cord neutral (center wire)
conductor to the SILVER colored center
terminal on the terminal block• Tighten the
screw securely•
_
,-
___--AocessoeVe,sorew
"_-J_S
_
-. F
T_rminal
L
_
_ _ /
# /
Neutral
t__
\ _/
Line 1
"--___X._-------_
(_RASS
terminal/
\,,
_
Internal
ground
"_-
(GREEN
screw)
Install
UL=approved
strata rehef here
Terminal
screw
recovery
slot
•
Attach the remaining two power cord outer
conductors to the outer, BRASS colored
terminals on the terminal block. Tighten both
screws securely•
ELECTRICAL
SHOCK HAZARD
Do not make a sharp bend or crimp wiring/
conductor
at connections.
7.
Follow manufacturer's
guidelines for firmly
securing the strain relief and power cord.
8.
Reinstall the terminal block cover•
If moving dryer from a 4-wire system and
installing it in a 3-wire system, move the internal
ground from the center terminal back to the
GREEN screw next to the terminal block.
If a terminal screw falls during cord installation,
it can be retrieved in the terminal screw recovery
slot below the access panel.
DO NOT remove
internal ground in
a 3-wire systemll
_li-_ _ ',,t
,,,,,
ii [''
; ,
/ ,,f'
Neutral
terminal