Installing The Display Assembly; Removing The Right Support Frame - Dell Latitude E5530 Owner's Manual

8. Remove the display assembly from the computer.

Installing the Display Assembly

1. Install the screws that secure the display assembly in place.
2. Insert the low-voltage differential signaling (LVDS) cable and wireless antenna cables through the holes on the
chassis.
3. Route the LVDS cable along its compartment and connect the connector to the system board.
4. Connect the antenna cables to their connectors.
5. Install :
a) palmrest
b) processor door
c) optical drive
d) keyboard
e) keyboard trim
f) bottom door
g) battery
h) SD memory card
6. Follow the procedures in

Removing the Right Support Frame

1. Follow the procedures in
2. Remove:
a) SD memory card
b) battery
c) bottom door
d) keyboard trim
e) optical drive
f) hard drive
g) processor door
h) palmrest
i) display assembly
3. Remove the screws that secure the right support frame to the computer.
4. Lift the right support frame away from the computer.
36
After Working Inside Your Computer .
Before Working Inside Your Computer .