Figure 30.
Installing the Palmrest
1.
Align the palmrest assembly to its original position in the computer and snap it into place.
2.
Connect the following cables to the system board:
a) power button flat flex cable.
b) fingerprint scanner flat flex cable
c) touchpad flat flex cable
d) media button flat flex cable
e) LED board flat flex cable
3.
Install the screws on the palmrest.
4.
Install the screws at the bottom of the computer.
5.
Install :
a) processor door
b) optical drive
c) keyboard
d) keyboard trim
e) bottom door
f) battery
g) SD memory card
6.
Follow the procedures in
Removing the ExpressCard Reader Cage
1.
Follow the procedures in
2.
Remove:
a) SD memory card
b) battery
c) access panel
d) keyboard trim
30
After Working Inside Your Computer .
Before Working Inside Your Computer .