Main Battery Connector - HP 325 - Notebook PC Maintenance And Service Manual

7. Slide the system board (5) out of the base enclosure.
Reverse this procedure to install the system board.

Main battery connector

The main battery cable is included in Cable Kit 605793-001.
Before removing the main battery cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the service door (see
6. Remove the hard drive (see
7. Remove the optical drive (see
8. Remove the fan (see
9. Remove the palm rest (see
10. Remove the keyboard (see
11. Remove the top cover (see
12. Remove the system board
Remove the main battery cable:
1. Remove the two Phillips PM2.5×4.0 screws (1) that secure the connector to the base enclosure.
94 Chapter 4 Removal and replacement procedures
Battery on page 48).
Service door on page
Hard drive on page
Optical drive on page
Fan on page 59).
Palm rest on page
Keyboard on page
Top cover on page
(seeSystem board on page
49).
51).
57).
64).
67).
71).
90).