HP 325 - Notebook PC Maintenance And Service Manual page 101

3. Remove the two Phillips M2.0×3.0 screws (3) that secure the system board to the base
enclosure.
4. Remove the optical drive extender by first removing the Phillips PM2.0×3.0 screw (1) that
secures the extender to the base enclosure.
5. Lift the system board slightly and then pull the extender straight out (2) from the system board.
6. Remove the hard drive extender by first removing the Phillips PM2.0×3.0 screw (1) that secures
the extender to the base enclosure.
Component replacement procedures 91