Standards Compliance; Firmware Installation - HP 316095-B21 - StorageWorks Edge Switch 2/24 Release Note

Standards compliance

Table 4 lists Fibre Channel standards compliance for firmware 09.02.00.
Table 4 Standards compliance
Category
Fibre Channel protocols
MIB-II groups
Fibre Channel classes of service
Fibre Channel Element MIB

Firmware installation

This section includes firmware installation information.
Prerequisites for installing and using firmware 09.02.00
Consider the following prerequisites for firmware 09.02.00:
• If you are using HAFM, firmware 09.02.00 requires HAFM 07.01.00 or later. This minimum
version lets you manage Edge Switches and Directors running 09.02.00 firmware. However, to
use the new features and enhancements added to firmware version 06.xx.xx and later, upgrade
HAFM to 08.09.01, which only runs on the HAFM Appliance (see
configure the McDATA 4 Gb/s Intrepid 6000 QPM when installed into a Director 2/64. The
QPM can be configured using HAFM Basic or CLI. McDATA EFCM 9.0 or later is capable of
configuring the McDATA 4 Gb/s Intrepid 6000 QPM when installed into a Director 2/64.
HP will be releasing support for EFCM soon.
• Check with HP Customer Support for the latest shipping version of HAFM. HAFM should be at the
minimum level before installing the new firmware.
If you are using HAFM to upgrade firmware, an Edge Switch 2/24 must be managed with HAFM
•
08.08.00 or higher before upgrading to firmware 08.xx.xx or later. If you upgrade to firmware
08.xx.xx or later using an HAFM release earlier than 08.08.00, the firmware upgrade may fail.
Firmware 08.01.00 introduced slightly more processor utilization, which can cause the download
Specifics
FC-GS-3
FC-GS-4
FC-PH Rev 4.3
FC-PH-2
FC-PH-3
FC-GS-2
FC-FLA
FC-FG
FC-SW-2
FC-MI
System
Interface
Address translation
IP
ICMP
TCP
UDP
SNMP
Class 2
Class 3
Class F
FE-MIB
Table
Director and Edge Switch release notes
3). HAFM is not able to
9