Service Call Errors - Canon iP4200 - PIXMA Photo Printer Service Manual

The remaining ink amount
13 times
unknown. [1683]
Ink tank not recognized. [1684]
14 times
Ink tank not recognized. [1410 to
15 times
1419]
Access cover open. [1200]
*1: Only for models supporting CD / DVD printing
*2: Only for models not supporting CD / DVD printing
2-2. Service Call Errors (by Cyclic Blinking in Orange (Alarm LED) and Green
(Power LED), or Alarm LED Lit in Orange)
Cycles of
blinking in
orange (Alram
LED) and green
(Power LED)
2 times Carriage error [5100]
3 times Line feed error [6000]
4 times Purge cam sensor error [5C00] - Purge unit (QM2-2208)
Error [Error code]
Resume/Cancel button, the automatic print
head alignment will not be re-done.
An ink tank which has once been empty is
installed. Replace the applicable ink tank
with a new one.
A non-supported ink tank is installed (the
ink tank LED is turned off). Install the
supported ink tanks.
An error occurred in an ink tank (the ink
tank LED is turned off). Replace the ink
tank(s).
Close the access cover.
(Replacement of listed parts, which are likely to be faulty)
- Carriage unit (QM2-2207)
- Timing slit strip film (QC1-6394)
- Logic board ass'y (QM2-2670)
- Carriage motor (QK1-1500)
- Timing sensor unit (QM2-2683)
- Timing slit disk film (QC1-6229)
- Feed roller ass'y (QL2-0925)
- Platen unit (QM2-2202)
- Logic board ass'y (QM2-2670)
- PAPER FEED MOTOR (QK1-1502)
1-7
is incorrect.
Printing with a
once-empty or
refilled ink tank
can damage the
print head.
If printing is
continued without
replacing the "no-
good" ink tank,
press the
Resume/Cancel
button for 5 sec. or
longer to record the
use of a refilled ink
tank.
Note:
After the above
operation, the
function to detect
the remaining ink
amount is disabled.
Solution
*1
*1