Installing Hardware Options; Installing Servers; Choosing A Configuration - HP 418800-B21 - StorageWorks Modular Smart Array 70 Storage Enclosure User Manual

IMPORTANT:
Be sure that the scissor-type locking latches engage the rack fully when the pins extend through
the holes marked with the template.
3. Slide the chassis into the rack.
4. Use the thumbscrews on the front of the chassis to secure it to the rack.
5. Use the shipping bracket to secure the enclosure for shipping:
IMPORTANT:
Use of the shipping bracket is required only when the rack is shipped with the MSA70 enclosure
installed.
a. Loosen the thumbscrew on the shipping bracket.
b. Slide the shipping bracket forward until it engages the chassis.
c.
Tighten the thumbscrew.
If you are installing the enclosure into a telco rack, order the appropriate option kit at the RackSolutions
website: http://www.racksolutions.com/hp. Follow the enclosure-specific instructions on the website to
install the rack brackets.

Installing hardware options

Install any hardware options before initializing the enclosure. For options installation information, see the
option documentation. For enclosure-specific information, see

Installing servers

Install the servers in the rack directly above the enclosure. See the server documentation.
NOTE:
When installing servers and enclosures, HP recommends installing all enclosures at the bottom of the
rack. To optimize cabling access, avoid interleaving the enclosure and server products.
Choosing a configuration
Cable procedures vary, depending on the configuration. Choose one of the following configurations.
24
Setting up the enclosure
15488
Installing hardware drives.