Related Manuals for Alliance Laundry Systems FLW1527C
Summary of Contents for Alliance Laundry Systems FLW1527C
- Page 1 Frontload Washers Metered Commercial FLW1527C Keep These Instructions for Future Reference. (If this machine changes ownership, this manual must accompany machine.) Part No. 803447R1 www.comlaundry.com January 2010...
- Page 3 Always contact the distributor, service agent, or the manufacturer about any problems or conditions you do not understand. 803447 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT WARNING W030...
-
Page 4: Table Of Contents
All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any means without the expressed written consent of the publisher. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Safety Information... -
Page 5: Safety Information
803447 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Safety Information Important Safety Instructions (Save These Instructions) To reduce the risk of fire, electric shock,... - Page 6 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 20. Be sure water connections have a shut-off valve and that fill hose connections are tight. CLOSE the shut-off valves at the end of each wash day.
-
Page 7: Installation
33.3 cm (13.1 in.) 71.1 cm (28 in.) 3.8 cm (1.5 in.) 803447 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Installation 68.3 cm (26.9 in.) 5.1 cm (2 in.) COIN MODELS 68.3 cm (26.9 in.) 5.1 cm... -
Page 8: Before You Start
NOTE: Some moisture in the wash drum is normal. Water is used during testing at the manufacturer. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Central Pay Models The machine is shipped from the factory with the Electronic Control Diagnostic Harness Assembly unplugged. -
Page 9: Installing The Washer
Figure 3 803447 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Step 2: Connect Fill Hoses Under certain conditions, hydrogen gas may be produced in a hot water system that has not been used for two weeks or more. - Page 10 (Black colored coupling for metric) Filter Screens Figure 4 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT IMPORTANT: Hoses and other natural rubber parts deteriorate after extended use. Hoses may develop cracks, blisters or material wear from the temperature and constant high pressure they are subjected to.
-
Page 11: Step 3: Connect Drain Hose To Drain Receptacle
IMPORTANT: Drain receptacle must be capable of handling a minimum of 3.5 cm (1-3/8 inch) outside diameter drain hose. 803447 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT W005I W005I Standpipe Installation Place the drain hose into the standpipe. -
Page 12: Step 4: Position And Level The Washer
(using a level). Washer should not rock. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Tighten the locknuts securely against the washer base. If the locknuts are not tight, washer will move out of position during operation. -
Page 13: Step 5: Remove The Shock Sleeves And Shipping Brace
Bolts and Lockwashers Figure 10 803447 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Step 6: Wipe Out Inside of Wash Drum Before using washer for the first time, use an all-purpose cleaner, or a detergent and water solution, and a damp cloth to remove shipping dust from inside wash drum. -
Page 14: Step 7: Connect The Washer To Electrical Power
110/120 Volts AC (alternating current) 15 Amps. Refer to Figure 12 to determine correct polarity of the wall receptacle. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 120±12 V.A.C. 120±12 V.A.C. -
Page 15: Earthing Instructions
Power Cord Earth (Ground) Prong Figure 13 803447 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 220 Volt, 60 Hertz without Plug The washer is designed to be operated on a separate branch, polarized, three-wire effectively earthed,... -
Page 16: Step 8: Check Installation
NOTE: Wiring to the central pay system should exit machine through hole in rear of control cabinet. Refer to Figure 14. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Run wiring from central pay system through here. -
Page 17: Operation
803447 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Operation Step 2: Close Loading Door Close loading door tightly. The washer will not operate with the loading door open. -
Page 18: Step 3: Add Laundry Supplies
Dispenser drawer requires a special tool for removal. Contact a service person if removal is necessary. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Step 4: Set Fabric Selector/Wash Temperature Push touchpad for HEAVY, NORMAL, PERM PRESS or DELICATES cycle. -
Page 19: Step 6: Start Washer
DOOR MUST BE CLOSED TO START WASHER. Figure 20 803447 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Indicator Lights WASH WASH is lit at the beginning of a wash cycle and will remain lit until the wash cycle is complete. -
Page 20: Maintenance
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Maintenance Replacing Hoses Hoses and other natural rubber parts deteriorate after extended use. -
Page 21: Reinstallation Of Shipping Materials
Refer to Installation section, step 5 for proper procedures whenever the washer is moved. 803447 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Cleaning Foreign Object Trap The washer’s pump has a trap that may collect foreign objects. -
Page 22: Troubleshooting
If using non-HE detergent, use only 1/2 of the detergent manufacturer's recommended amount. • Laundry load may be overloaded. Make sure you are using proper load sizes. © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Troubleshooting Possible Cause/Solution 803447... - Page 23 “H” on the valve bracket) and cold faucet is connected to cold mixing valve (indi- cated with “C” on the valve bracket). • Make sure laundry room water heater is adjusted properly. 803447 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT Possible Cause/Solution Troubleshooting...
-
Page 24: Copyright, Alliance Laundry Systems Llc – Do Not Copy Or Transmit
Phone: +1 (920) 748-3121 Nameplate Figure 22 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT When calling or writing about your unit, PLEASE GIVE THE MODEL AND SERIAL NUMBERS. The model and serial numbers are located on the nameplate. -
Page 26: Installer Checklist
• Connect Drain Hose to Drain Receptacle. CHECK • Position and Level the Washer. CHECK © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT • Remove the Shock H054IE0A H054IE0A • Wipe Out Inside COLD TLW1976N TLW1976N •...
Need help?
Do you have a question about the FLW1527C and is the answer not in the manual?
Questions and answers