Troubleshooting - Uniden MC535 Operating Manual

Color profile: Disabled
Composite Default screen
If your MC535 does not perform up to expectations, try the suggestions
listed below. If you cannot get satisfactory results, call the Uniden
Customer Service Center at (800) 586-0409, 8:00 a.m. to 5:00 p.m.,
Eastern Standard Time, Monday through Friday.
Unit does not
operate
Weak signal
Unit will not transmit
Excessive
background noise
Channel transmits
at 1W only
Channel display
flashes
C:\MANUALS7\mc535\Mc535.vp
Tue Sep 08 10:53:53 1998

Troubleshooting

Make sure that the volume control is in the ON
position.
Check in-line power fuse. Replace if
necessary with 6 amp fast-blow fuse only.
Check the power cord. Be sure that the
connections are intact and 12V power is
supplied.
Check antenna connections at base of
antenna and at the back of the radio.
Change to another channel and check
reception again.
Check to see if channel is "receive only."
Check antenna connections at base of
antenna and at the back of the radio.
Check and set SQUELCH control.
Check if FCC restricted channel. (See page 9
for more information).
Turn power off. Release the PTT switch, and
turn the radio back on.
Transmitter time-out activated. Release PTT
and allow radio to reset.
11