Sony NSR 1050H - Standalone DVR - 16 CH Installation Manual page 25

The cameras are registered.
↓
To configure alarm recording
Select [Automatic Alarm Record], and click [Next].
↓
A confirmation screen appears.
Click [Next}.
↓
Verify configurations, and click [Finish].
↓
Alarm recording starts.
When configuration is complete, the "Main" screen
appears.
After performing basic configuration, the values for
each setting will be as follows.
Setting Scheduled
recording
Image size Maximum image size supported by the camera.
Codec Codec that supports the maximum image
size.(If supported by both JPEG and MPEG4,
MPEG4 is selected.)
Frame rate JPEG:
Depends on storage
duration for
recorded data.
MPEG4:
Depends on bitrate.
Quality 50%
Level 3 (cameras
with 5 level
settings)
Level 5 (cameras
with 10 level
settings)
Bitrate Depends on storage
duration for recorded
data.
Recording –
trigger
Data storage Not changed from
location existing
configuration.
Audio Disabled
Data overwrite Not changed from
existing configuration.
Cleanup Deletes data that
exceeds storage
duration.
1) If the user has not configured storage location settings for
the camera, the capacity on the first partition of the unit's
internal hard disk is used to calculate other settings. If the
user has configured storage location settings, the capacities
for each of the locations are used to calculate other settings.
Alarm recording
JPEG: 10 fps
MPEG4: 10 fps
80%
Level 5 (cameras
with 5 level
settings)
Level 8 (cameras
with 10 level
settings)
MPEG4: 1.5 Mbps
VMD (Camera)
VMD (Recorder)
JPEG: Standard
mode
MPEG4: High-
performance
mode
Not changed from
existing
1) 1)
configuration.
Disabled
Not changed from
existing configuration.
Not changed from
existing configuration.
Step 3: Settings
25