Installing The Blade Server In The Bladecenter Unit - IBM eServer BladeCenter HS20 Type 8832 Installation And User Manual

The following illustration shows how to close the blade server cover.
Complete the following steps to close the blade server cover:
1. Read the safety information beginning on page vii and "Installation guidelines"
2. If you removed the blade bezel assembly, replace it now (see "Installing the
3. Lower the cover so that the slots at the rear slide down onto the pins at the rear
4. Pivot the cover to the closed position, as shown in the illustration, until it clicks

Installing the blade server in the BladeCenter unit

The following illustration shows how to install the blade server into the BladeCenter
unit.
Cover
pins
on page 19.
blade server bezel assembly" on page 36 for instructions).
of the blade server, as shown in the illustration. Before closing the cover, check
that all components are installed and seated correctly and that you have not left
loose tools or parts inside the blade server.
into place.
Type 8677
Chapter 3. Installing options
37