IBM eServer BladeCenter HS20 Type 8832 Installation And User Manual page 42

Complete the following steps to install an additional microprocessor:
28
BladeCenter HS20 Type 8832: Installation and User's Guide
1. Read the safety information beginning on page vii and "Installation guidelines"
on page 19.
2. Shut down the operating system, turn off the blade server, and remove the
blade server from the BladeCenter unit (see "Removing the blade server from
the BladeCenter unit" on page 20 for instructions).
3. Carefully lay the blade server on a flat, static-protective surface.
4. Open the blade server cover (see "Opening the blade server cover" on page
22 for instructions).
5. Remove the bezel assembly (see "Removing the blade server bezel assembly"
on page 23 for instructions).
6. Locate the microprocessor socket on the system board.
7. Remove the heat-sink filler.
8. Install the microprocessor:
a. Remove the protective cover, tape, or label from the surface of the
microprocessor socket, if one is present.
b. Touch the static-protective package containing the new microprocessor to
any unpainted metal surface on the blade server or any unpainted metal
surface on any other grounded rack component in the rack you are
installing the microprocessor in for at least 2 seconds; then, remove the
microprocessor from the package.
Attention: Do not use any tools or sharp objects to lift the locking lever
on the microprocessor socket. Doing so might result in permanent damage
to the processor board.
c. Rotate the locking lever on the microprocessor socket from its closed and
locked position until it stops or clicks in the fully open position
(approximately a 135° angle), as shown.
Attention: You must make sure that the locking lever on the
microprocessor socket is in the fully open position before you insert the
microprocessor in the socket. Failure to do so might result in permanent
damage to the microprocessor, microprocessor socket, and processor
board.
Lever closed
or
Lever
fully
open