Table of Contents
Advertisement
1
Setting Surface Controls
USINGTHE TOUCH CONTROL
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
The recommended
way to use the touch pads on the cooktop is shown in Fig. 1, Be
sure that your finger is placed in the center of the touch pad as shown. If the finger is
not placed on the center of a pad, the cooktop may not respond to the selection
made.
Lightly contact the pad with the flat part of your entire fingertip, Do not just use the
narrow end of your fingertip,
Fig. 1
OPE TING THE SINGLESURFACE DIANT
ELEMENT
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
The cooktop
has a single
radiant
surface
element
at the position
shown
on Figs. 2 & 3.
To Operate the Single Surface Element
Fig. 2
Fig. 3
1.
Place correctly sized cookware on the radiant surface element.
2.
Touch and hold the 0
key pad until a beep sounds. The power indicator light
power
above the (_ will turn ON. Note: If no other key pad is touched within 20
PowEr
seconds the request to Power ON the cooktop will clear,
3.
Touch and hold the []
pad for the desired element position until a beep is
On,O_F
heard. The display wil! show "0.0". Note: If no further pads are touched within
10 seconds the request to power the element ON will clear.
4.
Touch hi + pad once to turn ON the power level to HI or touch = Io pad
once for power level to Lo,
5.
Each touch of the hi + or - Io pad will increase or decrease the power
level. Lo is the lowest power level available. Note: The power level may
be adjusted at any time while the element is ON.
6.
When cooking has been completed touch the []
pad once to turn the
O_.eFF
element OFF and if no other surface element is used touch the (D key pad to turn off
power
the cooktop. Each surface element provides a constant amount of heat at each
setting, A glowing red surface heating area extending beyond the bottom edge of the
cookware indicates the cookware is too small for the surface heating area. Note: The
Hot Element (HE) message
will be showed on display for each element until the
heating surface area has cooled sufficiently.
CAUTI@N
Radiant surfaceelementsmay appear to have cooled after they have been turned OFF.The Hot Element (HE)messagewill be
showed and will continue to display until the glass cooktop has cooJeddown to a moderate level.The glass surface may still
be hot and burns may occur if the glass surface is touched before the display has turned OFF.
Donot place plasticitemssuchas saltand pepper shakers, s poon holders or plastic wrappings ontop of the range when it isin
use.Theseitemscouldmeltor ignite.Potholders, towelsor woodenspoons couldcatchfire ifplacedtoocloseto thesurfaceelements.
Hide quick links:
Advertisement
Table of Contents
