Table of Contents
Advertisement
Setting
urface Controls
SABBATHFEATUREMODE
I
i
[]
[]
[]
[]
[]
I
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
When the Sabbath feature is ON "Sb" will be showed on the radiant elements control
displays and on the Minute Timer Control display (Fig. t ). On induction element control
displays will be showed "-". Only radiant surface elements can be used during Sabbath
mode. The Timer feature is locked during the Sabbath mode.
To activate the Sabbath Feature Mode:
To activate the Sabbath feature at least one radiant cooking surface has to be active. If an
induction element surface is ON it will be automatically turned OFF when the Sabbath
mode is activated. Touch and hold for few seconds simultaneously
4- key of the Minute
Timer Control and _ key. After few seconds, "Sb" will be showed on the radiant elements
lock
control displays and on the Minute Timer Control display and "-" wilt be displayed on
induction element control displays.
To turn ON a Surface Element (only for radiant element) when the Sabbath Feature
is active:
Use the procedure as for operating a Radiant Element. If you turn ON a radiant surface
element during Sabbath mode the electronic surface element control will record the
request and execute it with a 15-30 seconds delay. So the element will start heating 15-30
seconds after the surface element control was turned ON. The element control display will
not show the settings because "Sb" is always displayed. When necessary, it is possible to
adjust the power of the surface element or to use the WARM feature but you have to
remember that the surface element control will adjust the temperature
with the same
delay.
To turn OFF the Surface
Element when the Oven Sabbath Mode is active:
To shut OFF the surface element 'while the Sabbath feature is ON, proceed as usual but
take note that the element will immediately turn OFF without any delay.
To deactivate the Sabbath Feature Mode:
Touch and hold for few seconds
simultaneously
4- key of the Minute Timer Control and _
key. When the Sabbath mode is deactivated the unit turns OFF.
Note: If a power failure occurs during sabbath mode when the power comes up "SF" will
showed on the radiant element control displays and on the minute timer control displays
(Fig. 2). On induction element control displays will show "-". All radiant elements will turn
OFF. The unit can be operated again as Sabbath mode.
Fig. I
Fig. 2
Hide quick links:
Advertisement
Table of Contents
