Disassembly And Reassembly Of The Driving Section - Hitachi NT65MA3 - 2-1/2 Angled Finish Nailer Service Manual

Finish nailers
Table of Contents

Advertisement

10-4. Disassembly and Reassembly of the Driving Section (See Fig. 20.)
Body Ass'y [30]
Blade Guide [37]
Guide Plate
(B) [31]
Hex. Socket Hd.
Bolt M6 x 30 [32]
Guide Plate
(A) [33]
Lock Lever [34]
Roll Pin D3 x 20 [43]
Fig. 20 Disassembly and reassembly of
the driving section
Nylon Nut M5 [44]
Sleeve [45]
Pushing Lever
Guide [58]
Roll Pin D4 x 14 [42]
Holder Spring [35]
Pushing Lever (B) [36]
Adjuster [38]
Ratchet Spring [39]
Pushing Lever (A) [40]
--- 25 ---
Hex. Socket Hd. Bolt
(W/Flange) M5 x 20 [78]
Roll Pin D3 x 28 [54]
[Tools required]
Hex. bar wrenches (4 mm and 5 mm)
Roll pin pullers (3 mm (.118") dia. and
4 mm (.157") dia.)
Flat-blade head screwdriver with small tip
(a) Disassembly
Continuously turn the Adjuster [38] in the
direction in which the nail is raised when
adjusting the driving depth (refer to
ADJUSTING THE NAILING DEPTH on
page 21 in the Instruction Manual) so that
Pushing Lever (A) [40] can be removed.
Remove the Hex. Socket Hd. Bolt (W/
Flange) M5 x 20 [78] with the hex. bar
wrench (4 mm) and remove the two Hex.
Socket Hd. Bolts M6 x 30 [32] with the
hex. bar wrench (5 mm). Now, the Blade
Guide [37], Guide Plates (A) [33] and (B)
[31], Pushing Lever (B) [36], etc. can be
removed.
Remove the two Ratchet Springs [39]
from the Adjuster [38] with the small flat-
blade screwdriver being very careful not to
lose them. Now, the Adjuster [38] can be
removed from Pushing Lever (B) [36].

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NT65MA3 - 2-1/2 Angled Finish Nailer and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

Nt 65ma3

Table of Contents