Disassembly And Reassembly Of The Driving Section And The Magazine Section - Hitachi NR 83AA2 Technical Data And Service Manual

10-4. Disassembly and Reassembly of the Driving Section and the Magazine Section

(1) Nose [33], Pushing Lever [46] and the related parts (See Fig. 18.)
Tool required
Hexagon bar wrench (5 mm)
(a) Disassembly
Perform disassembly according to 10-2-(3) to remove the Nose [33], Pushing Lever [46], and the other
parts.
Remove the Nose Rubber [61] from the Nose [33] by stretching the Nose Rubber [61] with a thin rod.
(b) Reassembly
Disassembly procedures should be followed in the reverse order. Note the following points.
Be careful of the mounting direction of the Nose Rubber [61]. Mount the Nose Rubber [61] aligning with the
shape of the Nose [33].
Hook the Spring [45] in the 3 mm dia. hole of the Nose [33] aligning with the shape of the Pushing Lever
[46]. (The Nose [33] has two 3 mm dia. holes, one is for hooking the Spring [45] and the other is for the
depth adjustment pushing lever kit (optional accessory).)
Do not insert a roll pin into the other 3 mm dia. hole. This hole is for the depth adjustment pushing lever kit
(optional accessory).
Nylock Hex. Socket
Hd. Bolt M8 x 22 [32]
Nose [33]
3 mm dia. hole
Nose Rubber [61]
Safety Bolt [44]
Spring [45]
Pushing Lever [46]
Nut M5 [47]
Fig. 18
--- 26 ---