Disassembly And Reassembly Of Handle - Hitachi NR90GC - 3-1/2" Gas Powered Clipped Head Framing Nailer Technical Data And Service Manual

(2) Disassembly and reassembly of Handle (A) [124], nail feeder and the related parts (Fig. 51)
[Tools required]
Phillips screwdriver
Roll pin puller (4 mm (0.157"))
(a) Disassembly
Remove the Lever Stopper [116] from the trigger of Handle (A) [124] with a hand.
Remove the Nail Rail [93] with a hand.
Loosen the Tapping Screw (W/Flange) D5 x 20 (Black) [126] and remove the Feeder Knob [125]. Then the
nail feeder ass'y can be removed.
Remove the Side Plate [55]. Then the Ribbon Spring [121], Spring D8 [122] and Pushing Lever Stopper [123]
can be removed.
Remove the Roll Pin D4 x 28 [118] in "A" direction as shown in Fig. 52. Then Nail Feeder (A) [112], Spring
[119] and Nail Feeder (B) [120] can be removed.
--- 57 ---