Reassembly - Hitachi NR90GC - 3-1/2" Gas Powered Clipped Head Framing Nailer Technical Data And Service Manual

(b) Reassembly
Reassembly procedures should be followed in the reverse order. Note the following points.
When mounting the cylinder head section to the main body, align the core of the Cylinder Ass'y [42] with the
core of the cylinder head section and tighten the Hex. Socket Hd. Bolts M5 x 20 [13] while pushing up the
Pushing Lever [64] to prevent the O-ring [15] from being pinched.
Perform wiring as shown in Fig. 25.
Perform wiring so that no
wire is placed on this area.
Fig. 25
--- 33 ---